Back to Blog
Air max compression boots7/12/2023 ![]() ![]() ![]() After inputting the program, the motherboard has strict regulations on the inflation time and pressure of each airbag. That is to complete the pressure test of the pneumatic compression leg recovery system. Manual installation is required to ensure that each air pipe will not leak during operation.Īfter installing and connecting all the compression boots leg recovery system accessories, there is very important work. It is difficult to install in place during the installation process. But the hose is very soft and tight to prevent air leakage.,if air leakage happens, then pneumatic compression devices are hard to increase blood flow and reduce muscle soreness. The air tube of the compression boots is very difficult to install because the hose needs to be inserted into the air nozzle on the leg of the pants. Installation of air hose of compression boots Battery life is very important to offer enough time for blood flow and deep vein thrombosis, same benefits for arm attachments and hip attachment. Intermittent pneumatic compression devices help reduce muscle soreness and also help leg recovery. The control unit decides the speed of blood circulation and the best compression boots offer faster recovery. The last step is to install the battery pack from the back, connect the connector, and close the cover on the back. Insert the air pump which decides the pressure intensity at the corresponding position, insert the air pressure detection device, then connect the conversion plug and screw it. The installation steps are as follows: first, place the purchased OLED display screen at the corresponding position and fix the screws second, install the motherboard in place, connect the display screen and the motherboard, and then fix the screws. ![]() The installation of the control unit is the most complicated part of the whole production process of the compression boots because there are many parts of the control unit, including the display screen, the main board, the pneumatic compression device, and the adapter plug. Installation of air hose of compression boots. The mass production process of compression boots is roughly divided into:ġ. This results in the slow batch production time of the compression boots. Since the value of pneumatic compression boots is relatively high, every link of the production process should be strictly controlled to prevent the return from causing bad use feelings to users. However, the final situation is often not what they want, because the production of compression boots is very delicate, and it takes a long time to ensure that each process is perfect. Many customers think that the production cycle of pneumatic compression boots is very fast, and they often come to urge the orders just placed. The mass production process of compression boots – ![]()
0 Comments
Read More
Leave a Reply. |